Yolodoor - Express Change Measurement (English version)

Our straightforward instructions will enable you to measure your door to make sure that the Express Change Yolodoor is perfectly suitable for installation.

Dificultad
1
2
3
4
5
ManualesOtras guíasYolodoorExpress Change Measurement (English version)

Para este manual necesitarás las siguientes herramientas y componentes

Manual: Paso a paso

Paso 1 Tools

You need 5 post-it notes, a pencil and a tape measure.

Paso 2 Step 1

Take the 5 post-its and stick them to the side of the frame so that they are easily accessible. Use the 5 post-its to roughly mark out an imaginary cross. Place the first post-it in the upper centre part of the door; the second approximately half-way up the centre; the third also in the lower centre part of the door and the fourth on the right. The fifth is placed by opening the door and attaching it to the inner frame leaf. Close the door and draw a line as close as possible to the frame, which will be used later to measure the thickness. Now you have your imaginary cross.

Paso 3 Step 2

 Take the first measurement of the upper part, from the right of the door to the centre, and mark it on the post-it: 400 mm. Continue on the top section, from the left of the door to the centre. In this case the measurement is 403mm. Note it down and add the two together. 400 + 403 is 803mm.

Paso 4 Step 3

 The second measurement, taken from the right of the door to the centre, also 400mm, is marked down. Continue on the middle section, from left to centre, where the measurement is 402mm. Mark it down and add the two together. 400 + 402 is 802mm

Paso 5 Step 4

Take the third measurement from right to centre and mark down 400mm again on the post-it and from left to centre, where the measurement is 403mm. Note it down on the post-it and add the two together. 400 + 403 is 803mm.

Paso 6 Step 5

For the fourth measurement, calculate the height. A measurement of 1600mm recorded from the base of the door is noted on the post-it. Measure from the upper section to the mark and note down the result. In this case, mark 425mm on the post-it and add the two together. 425 + 1600 is 2025mm.

Paso 7 Step 6

For the fifth measurement, continue measuring the height from the base of the door, measured at 1600mm, and note it on the post-it. Measure from the upper section to the mark and note down the result, in this case 426mm, on the post-it and add the two together. 426 + 1600 is 2026mm.

Paso 8 Step 7

The final measurement concerns the door leaf. Remove the post-it and measure from the initial mark, which gives 14mm. Draw a circle around it to distinguish it from other notes.

Paso 9 Step 8

It should be taken into account that the shortest measurement is used both for the width and the height. In this case, the width would be 802mm, the height 2025 and the leaf 14. This is how we tailor the Yolodoor to your needs.

Compartir este manual