Before you start, make sure the tablet is off.

To access the interior of the tablet, we will separate the screen. The plate and the components are installed in the rear housing.

Hold the screen with the suction cup and release the hooks located around the contour with a tablet opening tool.

The screen is connected on both sides with the data flexes. Partially separate the screen to be able to disconnect them and thus separate it.

Disconnect the data cable from the touch screen to be able to separate the screen, leaving only one of the sides attached.

Remove the stickers located around the base plate and holding the cameras.

Remove the 4 Phillips screws that hold the motherboard.

Separate the flex pushbuttons and chambers from the housing.

It is necessary to turn the motherboard to access the connectors.

Remove the adhesive covering the flex connector on the motherboard.

Disconnect the flex from the display, by pulling on the tab of the connector and pulling gently.

Disconnect the data cable from the touch screen.

Take off the flex from the back of the display.

The display is attached to the plastic frame by a thin strip of double-sided adhesive.

To detach it, pass the flat part of the spatula and go around the contour without force, holding the display with the suction cup.

The display is fragile and can be damaged if you do not handle it very carefully.