We started by heating the screen at about 60ºC for about a minute, to soften the adhesive. With the hot screen, we introduce a flat tool between it and the frame. Sliding it around the contour we will take it off.

We will take care in the left part and in the inferior part, since we can damage some flex.

Remove the six Phillips screws (PH # 00) that hold the shield and unlock it.

Unsecure the shield that covers the screen connector and disconnect it to be able to remove it.

To remove this case, remove the six Phillips screws (PH # 00) that hold it and pull it off with a flat tool.

We removed the three Phillips screws (PH # 00) to be able to remove the shield that covers the contacts of the cameras.

All that remains is to disconnect the camera and detach it from the chassis.