Insert the HOT GLASS in the microwave for the time specified in the instructions for use.

If you heat it too long, the gel inside will expand and the bag will be inflated until the content is poured.

The last minute in the microwave is advised to interrupt every 15 seconds and knead the gel inside with your hands to distribute the heat.

Before you start make sure the iPad is off.

Apply heat to the screen for a couple of minutes.

While suctioning up the screen, insert the tip of the prong under the digitizing glass and go around the contour to release the glue. Avoid the area highlighted in red (lower right side), since the flex cables are located there.

As it separates, use the thick prongs as a wedge so that it does not stick again.

Once detached, open the glass as if it were the cover of a book, leaving the flex data cables to the right.

Do not pull hard as it could break the glass. Apply heat as many times as necessary to remove it easily.

Remove the 4 Phillips screws that hold the display. Two of them are covered by a tape.

Lift the screen taking care not to damage the flex that connects to the board.

Remove the metal cover held by 3 Phillips screws.

Disconnect the flex cable from the motherboard and remove the display.

Disconnect the 2 flex cables.

Remove the adhesive covering the home button connector.

Disconnect the flex from the home button. To do this, pull the connector tab and pull the cable gently.

Separate the scanner.

Remove the SIM tray

Remove the adhesive covering the connector.

Disconnect the flex cable from the SIM card reader.

Take off and remove the SIM card reader.