First we will remove the card tray.

Using a thin tool we will open a small gap, through which we will introduce one or more plastic spikes with which we will be less likely to damage the housing. When opening the case we must disconnect the flex from the fingerprint reader.

Remove the ten Phillips screws (PH # 00) that hold the intermediate housing, and with the help of a flat tool we will unhook the housing.

We disconnect the battery to work with a greater security.

We remove the seven Phillips screws (PH # 00) that hold the lower case and the speaker, and with the help of a flat tool we will unhook both the case and the speaker.

We disconnect the interconnection flex at both ends.

We disconnect and remove all cameras from the motherboard.

We disconnect the flex from the screen, the flex of the proximity sensor and the coaxial cable.

Remove the Phillips screw (PH # 00) and with a flat tool we will lift the motherboard.

We take off the handset and proximity sensor.

We take off the flex of the side buttons.

Remove the coaxial cable, and the Phillips screw (PH # 00) that holds the auxiliary plate and with the help of a flat tool we will detach the plate.

We take off and remove the vibrator.

To finish we will only have to take off the battery from the screen that we have to replace.