To begin, we must apply heat to the back cover to soften the adhesive, and with the help of a suction cup and a very fine tool we will open a small hole through which we will insert a plastic spike, and thus we will avoid scratching the case.

We extract the seventeen Phillips screws (PH # 00) that hold the case, we will also remove the card tray, and with the help of a flat tool we will unhook all the sides of the case.

We disconnect the battery and the fingerprint reader.

We disconnect and remove the front camera.

We disconnected all the rear cameras to avoid damaging them when handling the motherboard.

We disconnect the interconnection flex, the coaxial cable, and peel off the adhesive that joins the base plate and the earphone, and with the help of a flat-tipped tool we will carefully lift the base plate.

We take off the flex from the side buttons.

We take off the area of the headset contacts with flat tweezers, and the headset with a thin metal tool.

We take off the battery with the help of the adhesive strips that are available, and then we will take off the adhesive that is underneath.

We disconnect and remove the coaxial cable from the flex bridge that joins the auxiliary plate and the motherboard.

We remove the speaker with the help of a flat tool.

We disconnect the flex from the screen, and with the help of a flat tool we will remove the auxiliary plate.

To finish, we will only have to take off the vibrator from the damaged screen that we have to replace.