First of all we removed the tray of the cards.

Apply heat to the screen to soften the adhesive that holds it, and with the help of one or more plastic tines we will remove all the edges of the screen, extract the three Phillips screws (PH # 00) that hold the shield covering the connectors and we can now disconnect the screen.

We disconnect the battery, remove the 16 Phillips screws (PH # 00) that hold the intermediate housing, and using a tool that is thin enough to unhook.

We disconnected the interconnection flex from both ends to work with greater comfort.

Remove the four Phillips screws (PH # 00) that hold the motherboard, lift it with the help of a flat tool, and disconnect the coaxial cable from the back of the motherboard.

We disconnect the flex connector with sensors and flash, unhook the cover and take off the proximity sensor.

We take off the damaged vibrator, and we can already desolder it to install the new one in its place.