Use a plastic tool to remove the battery cover, thus avoiding damaging or scratching the case.

Remove the battery by pulling on the bottom.

Remove the Torx screws that hold the antennas at the top corners.

In the photograph, the GPS antenna is located in the upper left corner and the BT antenna in the upper right.

Separate the lower antenna module with the help of a plastic tool, thus avoiding scratching or damaging the housing.

You must also remove the Torx screws left in view when removing the antennas and a small plug.

Separate the intermediate housing. Use a plastic tool to avoid damaging or scratching the phone.

Remove the small black pad and disconnect the flex from the SIM and SD cards.

Take off the flex of the SIM and SD cards from the metallic shields of the motherboard.

You can apply heat with the Hot Glass so that it takes off more easily.

Disconnect the flex cable from the display.

Separate the base plate by pulling on the top.

The plate will still be held by a flex data cable and the coaxial cable of the antenna.

Remove the plastic tape covering the connector and disconnect it next to the coaxial cable.

Release the connector and remove the camera.