To begin, we apply heat to the back cover to soften the adhesive that holds it, and with the help of one or more plastic spikes we will take off the back cover.

Manually open the camera rail, remove the six Phillips screws (PH # 00) that hold the intermediate housing, and with the help of a flat tool we will unhook the intermediate housing.

We disconnect all the components that are connected to the motherboard.

We remove the two plastic covers, and remove the ten Phillips screws (PH # 00) that hold the motherboard and the camera module.

We remove the shield of the first photograph, and we extract by sliding the motherboard and the camera module.

We disconnect the camera module from the motherboard.

We remove the four Phillips screws (PH # 00) that we indicate in the first picture, we take off the bezel with the help of a plastic spike, and below we will find another four screws the same as the previous ones.

Finally, we disconnect and take off the damaged top microphone that we have to replace.