First of all, we must apply heat to the back cover to soften the adhesive that holds the case, and with the help of one or more plastic spikes we will take off all the edges of the case.

We extract the five Phillips screws (PH # 00) that hold the trim, and with the help of a flat-tipped tool we will lift it.

We remove the twelve Phillips screws (PH # 00) that hold the intermediate casing, but before starting to unhook it we must extract the card tray, and then with the help of one or more prongs we will unhook all the edges of the casing.

We disconnect the battery to work with greater safety.

We peel off the adhesive that is above the front camera, and with the help of a flat tool we will disconnect and remove it.

We disconnect and remove the fingerprint reader.

We disconnected and removed all the rear cameras.

We disconnect the components that remain connected to the motherboard, and with the help of a flat tool we can lift, remove and install the new one that we have in its place.