We start by removing the SIM and SD trays. As we will have to start by removing the screen, we heat it to about 80º for about two minutes to soften the adhesive.

With the hot screen, we introduce a tool between it and the frame. Sliding it around the contour, we will take off the adhesive.

We will need a really fine and hard tool to be able to perform this step. In addition, it is very likely that we damage both the screen and the case.

Remove the Phillips screw (PH # 000) that holds the shield of the screen connector and remove it to disconnect it.

Remove the three Phillips screws (PH # 000) that hold the motherboard and then disconnect the coaxial cable. Now we disengage the plate and the module and take them off one another.

Now we move the speaker module and the motherboard apart so that the vibrator can be detached.