We apply heat to the back cover, and with the help of a suction cup and a fine tool we will open a small hole through which we will introduce one or more plastic spikes and we will take off all the edges of the case, we can repeat the process of applying heat as many times as we need it, since the case is quite well glued.

With the help of a plastic tool we will unhook the cover from the fingerprint reader connector, and once it is removed we will be able to disconnect it.

We extract the eleven Torx screws (T5) that hold the intermediate housing, and with the help of a flat tool we will unhook it.

We disconnect the battery to work with greater safety.

We remove the tray from the cards.

We disconnect all the components that prevent us from lifting the motherboard, we remove the two Torx (T5) screws that hold it, and with the help of a flat tool we can lift it.

Finally, we only have to disconnect all the cameras that are connected to the motherboard that we are going to replace.