Before starting make sure the phone is switched off.

Remove the back cover with the opening tool, this will prevent scratches on the housing.

Remove the battery by pulling on the bottom.

Remove the microSD card.

Remove the SIM card.

Remove the 8 Phillips screws to remove the middle housing.

Loosen the plastic tabs around the equipment with the opening tool.

Separate the intermediate housing.

Unplug the camera from the motherboard and pull it gently to remove it.

Unplug the camera from the motherboard and pull it gently to remove it.

Unplug the bottom plate from the motherboard.

Disconnect the data cables from the screen.

Desconecte el cable coaxial RF.

Separate the base plate from the chassis with the opening tool.

Insert the HOT GLASS in the microwave for the time specified in the instructions for use.

If you heat it too long, the gel inside will expand and the bag will be inflated until the content is poured.

The last minute in the microwave is advised to interrupt every 15 seconds and knead the gel inside with your hands to distribute the heat.

Apply heat to the edges of the screen for a couple of minutes.

Insert the tip of the tine behind the glass of the digitizer and go around the contour releasing the glue.

Avoid cutting the flex cable through the barb.

Separate the digitizer and clean the remaining glue from the housing before installing the new one.

The digitizer is fragile and can break if you force or tamper with it. Apply enough heat as many times as necessary to remove it easily.

Peel off the flex cables from the LCD display on the back.

Separate the display from the chassis by pushing the flex cables in the back.