Before you start, make sure the phone is off.

To remove the back cover, use an opening tool to avoid damaging or scratching the case.

Remove the battery by pulling it from the bottom.

Remove the seven Phillips screws to open the housing.

Separate the housing with an opening tool to avoid scratching or damaging it.

Disconnect the flex from the front camera and gently pull out the component.

Disconnect the coaxial cable from the motherboard.

Disconnect the flex from the touch screen of the motherboard.

Unfasten the side buttons of the housing.

Disconnect the flex from the LCD display of the motherboard.

For convenience, remove the adhesive that covers the interconnection flex from the motherboard.

Disconnect the coaxial cable from both ends.

Use an opening tool to pry carefully and remove the base plate from the housing.

To remove the headset, carefully remove it from the case.

Use a tool to pry and thus remove the lower module.

Carefully take off the interconnection flex.

Use a pry tool and remove the plate where the vibrator and microphone are connected.

Insert the HOT GLASS in the microwave for the time specified in the instructions for use.

If you heat it too long, the gel inside will expand and the bag will be inflated until the content is poured.

The last minute in the microwave is advised to interrupt every 15 seconds and knead the gel inside with your hands to distribute the heat.

Apply heat for a couple of minutes.

Insert the tip of a prong into the joint between the digitizer and the housing.

Move it around the contour avoiding the upper corner where the flex cable of the digitizer passes, you could cut it.

Take off the digitizer. Make sure that the flex cable does not jam or bend as it could break.

Do not use force to remove it, the display is fragile and you can leave.