To start, we must remove the card tray using the removal tool.
Step 2 Back case
With the help of a fine tool we will unhook all the edges of the back cover.
Step 3 We disconnect battery
We remove the three Phillips screws (PH # 00) that hold the shield covering the connectors, and disconnect the flex from the battery to work with greater security.
Step 4 Cover
We remove the four Phillips screws (PH # 00) that hold the cover and remove it.
Step 5 Drums
We disconnect the flex from the screen and the interconnection flex that is located above the battery, and using the orange adhesive strips that protrude from the side of the battery, we will take it off.
Step 6 Cameras
We disconnect and remove the rear and front cameras.
Step 7 Side push buttons
We disconnect and take off the side buttons.
Step 8 Motherboard
We disconnect the coaxial cable, remove the two Phillips screws (PH # 00) that hold the motherboard, and with the help of a flat tool we will lift the plate.
Step 9 Proximity sensor
We take off the proximity sensor with the help of flat tweezers.
Step 10 Aurcicular
With a thin metal tool we will take off the headset, being careful not to damage it.
Step 11 Speaker
We remove the seven Phillips screws (PH # 00) that hold the speaker, and with the help of a flat tool we unhook the speaker.
Step 12 Auxiliary board
We disconnect the coaxial cable and the interconnection flex, and with the help of a flat tool we will detach the auxiliary plate.
Step 13 Fullscreen
And finally we just have to take off the vibrator from the broken screen that we have to replace.
Video Tutorial summary
In this video you can watch a quick summary of the tutorial, but we recommend to follow the complete tutorial, with its explanations and detailed images.