To begin, we must apply heat to the back cover, and with the help of a fine tool we will open a small hole through which we will introduce one or more plastic prongs, with which it will be less likely that we will damage the case.
Step 2 Middle housing with NFC
We remove the twenty-one Phillips screws (PH # 00) that hold the intermediate housings, disconnect the flex from the rear flash that is attached to the housing, and with the help of a flat tool we will unhook the housings.
Step 3 We disconnect the battery
We disconnect the battery to work with greater safety.
Step 4 Charging connector
We disconnect and remove the charging connector.
Step 5 Interconnection flex
We disconnect and remove the interconnection flex.
Step 6 Coaxial cables
We disconnect and remove the coaxial cables.
Step 7 Flex bridge
We disconnect and take off the flex bridge.
Step 8 Rear cameras
We disconnect the four connectors from the cameras and we can lift the module.
Step 9 Front cameras
We extract the Phillips screw (PH # 00) that holds the shield that covers the camera connectors, and with the help of a tool we disconnect the front cameras.
Step 10 Base plate
We extract the Phillips screw (PH # 00) that holds the motherboard, disconnect the connectors that are connected to the motherboard, and with the help of a flat tool we will lift the motherboard.
Step 11 Vibrator
Finally, with the help of a fine tool, we will take off the vibrator that we have to change.
Video Tutorial summary
In this video you can watch a quick summary of the tutorial, but we recommend to follow the complete tutorial, with its explanations and detailed images.