To remove the back shell, we introduce an opening tool between it and the frame and doing lever movements we will unhook it. You have to be careful since the housing is very fragile and breaks easily

We remove the rear chamber, the retaining screws, the flex of the battery, the connection flex of the plates and the coaxial cable.

We remove the motherboard to access without any problem to the headset.

We remove the receiver, disconnect the motherboard and remove it. We do the same with the ignition and volume buttons and with the battery.

We remove, desoldando, the vibrator and the loudspeaker of the auxiliary plate.

We remove the remaining components of the auxiliary plate, and remove this. Then we remove the central button / fingerprint detector.

We apply heat to the screen, about 60 seconds at 60 degrees. When the screen is hot we introduce an opening tool and very carefully, without going over the frame of the screen, we will separate it all over the contour.