In this step we will have to remove all the feet of the drone. To do this, we remove the four Torx T5 screws that hold each foot and remove it. In case of the front feet, we will have to disengage and disconnect the antennas.

Now we remove the two Torx T4 screws that hold the motor connector plate to disconnect it. We will do this in the four engines.

We remove the plastic washers that hold the chassis and we disengage it by sliding the cables through the holes.

Remove the two screws that hold the control camera to disengage it and be able to peel off the adhesive covering the base plate.

Now all you have to do is remove the three Torx T5 screws that hold the fan and disconnect it.