With the help of a fine tool we separate the casing from the chassis around its entire contour until it is separated

We remove the protective adhesive and expose the battery connection with the help of a soldering iron, we release the soldering points that join the battery to the motherboard

We extract the microphone from its housing

Then we remove the adhesives that hold the speaker cables, remove them and with the help of a Phillips screwdriver (PH # 00) remove the speaker

As in the previous step, we remove the stickers from the speaker on the left side and remove it with the help of a Phillips screwdriver (PH # 00) and remove it from its housing

Then we release the interconnection flex in its lower part

We take off the NFC antenna from its base to be able to remove it

Then we remove the three Phillips type screws (PH # 00) that hold the motherboard, we release the flex from the digitizer and remove it with all the components attached to it

It is not necessary to desolder the components since we remove everything together

Finally we remove the battery with the help of a thin plastic tool and then we release all the tabs that hold the LCD and we can remove it