We started by heating the screen at about 60ºC for about a minute, to soften the adhesive. With the hot screen, we introduce a flat tool between it and the frame. Sliding it around the contour we will take it off.

We will take care in the left part and in the inferior part, since we can damage some flex.

Remove the shields covering the connectors, levering and releasing the notches that hold it. Then we disconnected the screen to be able to move it away.

First we remove the central adhesive that covers one of the screws. Then we removed the six Torx T5 screws. Now we remove the processor shield to remove another four Torx T5 screws and remove the heatsink.

We will be careful not to touch the thermal paste to avoid staining the base plate as we could damage it.

Now we remove the four Torx T5 screws that hold the housing and disconnect the flex with microphone and sensor to be able to move them away.

We put aside the camera of facial recognition, we disconnected the microphone, we removed the metallic support and we took off the microphone of the chassis.