Before starting, make sure the tablet is off.

Hold the screen with the suction cup. Separate the housing around the entire contour, levering with the double opening tool.

Pull the suction cup while holding the lid with the tool to separate it.

Disconnect the data flex from the touch screen. To do this, we activate the plastic tab of the connector and gently pull the flex cable.

The screen is attached to the chassis by a strip of adhesive that runs all the way around.

To detach it we will apply heat to soften the adhesive and to peel off easily.

We suggest 2 methods:

1. Hot Glass: Heat blanket for microwaves. (Advised)
2. Hot air nozzle: Incuded in the SMD welding stations.

Heat the edges of the touch screen glass with the method you prefer.

Insert the tip of the prong between the glass and the plastic chassis.

Go around the contour by peeling off the adhesive strip all around.

As you separate the glass, insert thicker quills as a wedge, so that the adhesive does not stick again.

Avoid the area of ??the data flex since you could cut it with the pick.

Separate the touch screen, starting from the opposite side of the data flex.

Finally, detach the flex data cable.