We will start by removing the screen, for this we will warm it to about 60ºC during a minute approximately.

With the hot screen, we will introduce a tine or another flat opening tool and move it around the contour to remove the adhesive.

To remove the screen, we will disconnect it from the bottom.

Remove the ten Phillips screws (PH # 00) that hold the shield, disconnect the battery and remove it.

Uncap the housing that covers the auxiliary plate and then disconnect the coaxial cable. Now, we will raise it to disconnect the interconnection flex.

We disconnect the flex from the charging connector and disengage it. We take off the loudspeaker module and we will have to first remove the side antenna with coaxial cables as we will see in the next step.

Unlatch the side antenna and we can remove the speaker module.

We disconnect the flex from the base plate, we take it off the chassis and we disengage it.

To finish, we will press the keys from the outside to the inside to disengage them.