We will start by removing the screen, for this we will warm it to about 60ºC during a minute approximately.

With the heating screen, we will introduce a tine or another flat opening tool and move it around the contour to remove the adhesive.

To remove the screen, we will disconnect it from the bottom.

Remove the ten Phillips screws (PH # 00) that hold the shield, disconnect the battery and remove it.

Remove the indicated screw and remove the plastic case. Then we will disengage the lateral support of coaxial cables.

We take off and disconnect the auxiliary plate.

In this step we remove the flex with load connector, the support of coaxial cables and the loudspeaker module.

We disconnect the flex from the power button and disengage the chassis support.

To finish, we will press the button from outside to disengage it.