To remove the back shell we have applied a little heat to the back to soften the adhesive, with the help of a plastic spike we unhook the shell, and we will have to disconnect the flex from the fingerprint reader.

We extract the six Phillips screws (PH # 00) that hold the upper case, and with a flat tool, we will unhook it.

We disconnect all the components that are connected to the motherboard and remove the tray from the cards.

We extract the motherboard.

Take off the battery, taking care not to damage it too much.

Remove the four Phillips screws (PH # 00) that hold the module and unhook it with the help of a flat tool.

We disconnect all the components that are connected in the auxiliary plate, and with the help of a flat tip tool, we will take it off.

We remove the Phillips screws (PH # 00) and we can remove the connector.

We remove the coaxial cables.

We extract the eleven Torx screws (T5) that hold the frames, and simply doing a little pressure on them will take off.

We take off the flex from the screen, and apply heat to soften the adhesive that holds the screen to the chassis, and with one or more barbs we gradually take off all the edges of the screen.