To begin we must apply heat to the back cover, and with the help of a fine tool we will take off the casing a little, being careful not to damage it, and to avoid damaging it we will introduce some plastic prongs, with which it is less likely to scratch the casing.

We remove the fifteen Phillips screws (PH # 00) that hold the loudspeaker module and the upper casing, and uncoupling them with a flat tool.

We disconnected the battery to avoid possible damage.

We disconnect and remove the front camera.

We disconnected from the base plate the flex of the ignition button and the flex of the screen.

We disconnect and extract the audio connector.

Remove the three Phillips screws (PH # 00) that hold the motherboard, and remove the tray from the cards before lifting the motherboard.

To finish, with the help of flat clamps we will take off the broken handset that we are going to replace.