Before starting, make sure that the mobile is turned off.

Remove the back cover with the opening tool, this will prevent scratches on the housing.

Remove the battery by pulling on the bottom.

Remove the micro SD card.

Remove the micro SIM card.

Remove the 9 Phillips screws that hold the intermediate housing.

Remove the intermediate housing with the opening tool.

Disconnect the upper end of the coaxial antenna cable.

Disconnect the data flexes from the digitizer and display.

Disconnect the lower end of the coaxial cable.

Separate the base plate from the chassis.

Remove the Phillips screw that holds the bottom plate.

Peel off the bottom plate of the chassis.

Unplug and detach the flex cable from the digitizer.

To detach the glass from the digitizer we will apply heat in order to soften the glue and that it separates easily.

To heat the screen we will use the HOT GLASS.

Insert the HOT GLASS in the microwave for the time specified in the instructions.

To heat it evenly, it is necessary to interrupt the microwave every 30 seconds to distribute heat throughout the HOT GLASS with your hands.

Apply heat to the edges of the screen for a couple of minutes.

Insert the tip of the tine behind the glass and go around the contour to detach it.

Avoid passing the barb around the corner of the flex as it would cut it.

Separate the digitizer by passing the flex carefully so as not to break it.

Remove the key with tweezers.

Take off the flex on both sides of the chassis.

Pull gently on it to remove it.