We start by removing the two screws that hold the lid with the tool that brings the device itself or another tool. Then we will withdraw it.

We remove the ten Torx 6 screws and the two Phillips screws (PH # 00), one of them will be found behind an adhesive.

We disconnect the coaxial cable, the display, the touch screen and disengage the proximity sensor.

Unseat the flex of side push buttons and take off the battery. We lift the base plate and disconnect the interconnection flex with the auxiliary plate. Now we can remove the motherboard along with the other components welded to it.

We remove the plate with the rest of the components. Then we disconnect the coaxial cable and take off the flexes of the metal shield.

To finish, remove the Phillips screw (PH # 00) that holds the plate and then take it off. We just need to desolder the flex.