First of all, we must apply heat to the back cover to soften the adhesive that holds the case, and with the help of one or more plastic spikes we will take off all the edges of the case.

We extract the five Phillips screws (PH # 00) that hold the trim, and with the help of a flat-tipped tool we will lift it.

We remove the twelve Phillips screws (PH # 00) that hold the intermediate casing, but before starting to unhook it we must extract the card tray, and then with the help of one or more prongs we will unhook all the edges of the casing.

We disconnect the battery to work with greater safety.

To finish, we only have to remove the camera that we have to replace, for this we must remove the adhesive that is above the connector, and with the help of a flat tool we will disconnect it to connect the new camera that we have in its place .