We will start by removing the back cover. For this we will use an opening tool, which we will move along the contour of the phone to release the notches that hold it.

To remove the battery, we will lift it with the help of an opening tool or directly with your hands,

To remove the cards we will simply pull them out.

To remove this case, first remove the seven Phillips screws (PH # 00) that hold it to the chassis. Once the screws are removed, we will use a flat tool to release it.

In this step, we will disconnect the components of the plate to be able to withdraw it later.

After disconnecting the components of the motherboard, we will remove it to be able to subsequently slide and remove the flex from the digitizer.

Now, we will heat the screen for about half a minute at about 60ºC to soften the adhesive.

With the hot screen, we will slide a prong between it and the frame to remove the adhesive that holds it.

Before removing the screen, we will remove the flex from the digitizer and then slide it through the hole in the chassis. If necessary, remove the remaining adhesive that may be on the top of the screen.