We will start by heating the back cover to soften the adhesive that holds it. We will heat it to about 50ºC for about a minute.

With the hot lid, we will introduce an opening tool between it and the frame. We will slide it around the contour to remove the glue.

In this step we will remove the shielding of the plate and the antenna module. To do this, we will remove the seven screws that we pointed out in the first image. After removing the screws, we can disengage them.

To remove the auxiliary antenna plate, simply remove the screw that holds and disengage.

In this step, we disconnect the flex from the audio connector on the motherboard. Then, to disengage the connector, we introduce a tool through the front hole and, without much effort, we will lift it and disengage it.

To finish, we disconnect the flex from the base plate and then take it off the chassis.