To begin with, we remove the tray from the cards with the help of the extraction tool.

With a thin enough tool we will unhook all the edges of the back cover, then we must remove the three Phillips screws (PH # 00) that holds the shield that protects the connectors, and disconnect the fingerprint reader.

Remove the seven Phillips screws (PH # 00) that hold the module and unhook it.

Disconnect and detach the side buttons.

We disconnected the flex from the screen and the interconnection flex.

Remove the five Phillips screws (PH # 00) that hold the upper antenna and we can unhook it.

We disconnect the digitizer connector and the coaxial cable.

We extract the three Phillips screws (PH # 00) and we can remove the base plate.

Helping us with a metallic pick we will take off the receiver.

We remove the coaxial cable, disconnect the interconnection flex from the auxiliary plate and detach it, both the auxiliary plate and the vibrator.

Pulling the adhesive from the bottom of the battery, we will lift the battery enough to insert a tool and take it off.

Finally we will take off the interconnection flex.