To open the lid it is necessary to remove two "pentalobe" screws.
Use a suitable screwdriver.
Step 2
Press with your fingers forward to move the lid.
Step 3
Remove the battery cover.
Step 4 Battery connector
The battery connector is supported by two Phillips screws.
Remove the part under the upper screw colored green and keep it. Due to its size it is very easy to lose it.
Step 5
Disconnect the battery with a plastic tool so as not to damage the board or the connector.
Step 6 Remove battery.
Pull the plastic strip to detach the battery.
Step 7
Remove the connector cover. It is secured with two 1.5 and 1.2 mm Phillips screws.
Step 8 Bottom connector base plate
With the help of an opening tool disconnect and separate the flex cable.
Step 9 Cable coaxial
Disconnect the coaxial cable from the motherboard.
Step 10
Remove the two 2.4mm Phillips screws.
Do not lose the piece of plastic that will be loose after the screw on the left.
Step 11 Bottom module
The lower module is attached to the chassis. You must pry gently with an opening tool to release it.
Step 12 Motherboard connector cover
Remove the screws from the cover:
2.6mm
1.2mm
1.3mm
2.7mm
Step 13 Baseboard connectors
Disconnect the connectors from the motherboard:
Headphone Flex, jack and volume buttons
Flex of the rear camera.
Digitizer Flex (touch screen).
Flex of the LCD display.
Step 14 Rear camera
The camera is held by the connector to the motherboard.
Unplug it with an opening tool.
Step 15
Remove the clip that is attached with a 1.5mm Phillips screw.
Step 16
Use a flat screwdriver to remove the 4.8mm Standoff screw
Disconnect the flex cable from the WIFI antenna.
Step 17 Base plate screws
Remove the screws that hold the motherboard:
2.6mm Phillips (remove the attached cover)
4.8mm Standoff (see previous step)
2.4mm Phillips
Parte inferior:
2.5mm Phillips
3.6mm Standoff
Step 18 Motherboard
Holding it from the bottom, remove the motherboard carefully.
Step 19 Vibrator
The vibrator is attached to the chassis. You must pry it off, we advise our curved tip tool to extend it without damaging the chassis.
Video Tutorial summary
In this video you can watch a quick summary of the tutorial, but we recommend to follow the complete tutorial, with its explanations and detailed images.