To open the lid it is necessary to remove two "pentalobe" screws.
Use a suitable screwdriver.
Step 2
Press with your fingers forward to move the lid.
Step 3
Remove the battery cover.
Step 4 Battery connector
The battery connector is supported by two Phillips screws.
Remove the part under the upper screw colored green and keep it. Due to its size it is very easy to lose it.
Step 5
Disconnect the battery with a plastic tool so as not to damage the board or the connector.
Step 6 Remove battery.
Pull the plastic strip to detach the battery.
Step 7
Remove the connector cover. It is secured with two 1.5 and 1.2 mm Phillips screws.
Step 8 Bottom connector base plate
With the help of an opening tool disconnect and separate the flex cable.
Step 9 Cable coaxial
Disconnect the coaxial cable from the motherboard.
Step 10
Remove the two 2.4mm Phillips screws.
Do not lose the piece of plastic that will be loose after the screw on the left.
Step 11 Bottom module
The lower module is attached to the chassis. You must pry gently with an opening tool to release it.
Step 12 Wifi antenna
Remove the two 1.6mm Phillips screws.
With the help of a special spike, take off the wifi water from the rest of the module.
Step 13
Once detached the metal part can take off the rest pulling gently.
Video Tutorial summary
In this video you can watch a quick summary of the tutorial, but we recommend to follow the complete tutorial, with its explanations and detailed images.